1. Site Orientation/ Induction
2. Access ceiling space via Ladder
3. Install new ceiling mounted unit
4. Run Cables through existing ceiling space
5. Run Pipe work  through existing ceiling space
6. Cut copper pipe with tube cutter
7. Welding copper tube
8. Cut plasterboard using a key hole plasterboard saw
9. Install ceiling registers
10. Install flexi ductwork and zone motors in ceiling space
11. Connect new cables into electrical plant/ equipment
12. Connect new cables into existing switchboard
13. Refrigerant charge the system using a vacuum pump
14. connect pressure pump
15. Test the electrical installation
16. Fill out and issue Electrical Certificate of Compliance
17. Cleaning up work area
18. Vacuum

When you insert a template it automatically brings with it:

1. The main process step
2. The sub process steps associated in undertaking the task
   1. The potential hazards associated with undertaking the task (you can also delete or add any of these with a simple click)
   2. The Risk Rating for undertaking the task (You can also change this if you want to)
   3. The Hazard Control measure (you can also delete or add any of these with a simple click)
   4. The revised risk rating after applying the control (You can also change this if you want to)
   5. Any required PPE (you can also delete or add any of these with a simple click)
   6. Any applicable licences or qualifications required (you can also delete or add any of these with a simple click)
   7. Any pre operational inspections required (you can also delete or add any of these with a simple click)
   8. Any applicable legislation or codes of practice (you can also delete or add any of these with a simple click)

There is an example of a SWMS generated from the system available for download. 

The Main points in this example SWMS are templates that have been inserted into the “Site Specific SWMS” to build it.  

 See JSEAsy features and demonstrations for  video demonstrations on how this works (They run for around 4 minutes each)